Tecnosida Logo

Recycling and dedusting system

Applied in metal scraps recovery

Our target: production scraps recovery

Tecnosida® was contacted to design a system that would allow the production scraps (copper fiber trimmings), which are continuously present on the work surfaces, to be recovered AUTOMATICALLY. In fact, manual recovery is inefficient as it forces the operator to stop in order to clean; moreover, recovering the trimmings is difficult due to their geometry.

Our solution: conveying, extraction hoods and cyclones

Following an adequate inspection, Tecnosida® designed a solution that ensures a quick elimination of the trimmings from the work surface, and at the same time allows all the residues to be recovered.

This solution is based on:

1. A pneumatic conveyor system that carries the trimmings to a collection point;

2. The use of dedicated exhaust hoods, located at the end of the work surface;

3. The installation of a cyclonic separator, provided with a special discharge system; this allows the material to be collected on a conveyor belt that goes directly to the recovery mill.

Contact Tecnosida to receive specific advice adhering to your technical situation!

Recycling and dedusting system / Info Request

Send here technical requirements, for proposal or proposals for collaboration, we are committed to respond within 24 hours.

Privacy The data provided will be used exclusively for the purposes strictly related to the provision of information on services and products offered by Tecnosida srl The treatments can be performed using paper or computer and / or remote even by third parties for whom the knowledge of your personal information is necessary or useful to carry out the business of providing information on services and products Tecnosida srl; the processing of your data will be a way as to guarantee security and confidentiality. The data controller is Tecnosida Srl with headquarters in Via C. Colombo 64 in Carate Brianza. In regard to the processing of your data, you can exercise your rights pursuant to art. 7 of Legislative Decree 196/2003. Sending the following request implies the acceptance of all the clauses on data just explained.

Related products

Hoods | Industrial aspiration and uptake systems: The design of the system included the design of custom cups, blower tubes and the complete study of the processing area

CYCLONE| Dust and particles separation: The solution involved the installation of a cyclone separator, fitted with special exhaust system, for the collection and recovery of metal discharge